The helmets of Co. ESSAFE the demands of EN 397-1195/ pr A1: 1998 and have been tested by VUBP-AO 235 -Praha/ Czech.
The nap strap must be adjusted to allow the helmet to fit the wearer's head correctly.
The helmet offers the wearer some degree of protection aganist fallings objects.
The helmet should be cleaned by using a mild detergent in warm water. Direct contact with solvents and alcohols may reduce the resistance of the shell ans should be avoided.
Before each use the helmet should be inspected for cracks, cuts or other damage. Any helmet involved in an accident should be replaced for safety reason. Ensure the harness is always assembled to the helmet.
Store the equipment clean and dry in normal room temperature
The chinstrap fastener shall be fitted at both sides of the temperature.
7) Spare parts
Spare parts are available for the ESSAFE industirial safety helmets.
The ESSAFE has been tested and approved for use according to the following optional requirements in EN 397.
9) Helmets from Polyethylen should be replaced after 3 years of conventional use.
Never modify this device other than those recommended by the manufacturer.
Never use the helmet if its cracked or cut. Do not paint or spraypaint helmet.